User Manual

Installation
Page 28 MDE-4199 Contactless Smart Card Retrofit Kit M05205K00X Installation Manual • January 2005
Figure 20: Top View of Card Reader Mounted In Option Door
10
Using a cross-tip screwdriver, remove the screw that secures the ESD ground cable (Figure
20) to the option door chassis. Retain the screw for reinstallation.
11 Using a 1/4-inch nut driver, remove the four hex head fasteners (Figure 20) that secure the
card reader bracket (Figure 20) and the card reader to the options door. Dispose of the card
reader and retain the fasteners for reinstallation.
Note: Make note of the card reader’s gasket orientation. This information will be useful when
installing the new M00682B001 Card Reader Gasket. Also, ensure that the option door
surface has been cleaned with isopropyl alcohol and a clean cloth prior to installing the
new card reader gasket.
12 Remove the old card reader gasket (Figure 20) from the options door. Use a putty knife if
necessary.
13 If installing a dual head card assembly on Side B, repeat steps 1 through 11.
Installing The Contactless Smartcard Reader Assembly
1 Remove the adhesive backing from the M00682B001 Card Reader Gasket and carefully place
the gasket over the card reader opening from the inside of the opened option door.
Note: Fueling units that contain the InfoScreen option may require the removal of the lower
right Infoscreen fan screw (Figure 20) to allow installation of the new RF Reader
bracket. The screw may be discarded once the installation has been completed.
2 Obtain the M03311A001 Dual Head Card Assembly (Figure 21) and T19632-02 Card Reader
Mounting Bracket (Figure 21) from the kit, and assemble the reader and bracket for
installation onto the option door.
Data/Power
Cable
Connection
ESD Ground
Connection
Hex Head
Fastener
Hex Head
Fastener
Hex Head
Fastener
Card
Reader
Bracket
Card Reader Gasket
Lower Right Fan Screw