User Manual

MDE-4199 Contactless Smart Card Retrofit Kit M05205K00X Installation Manual • January 2005 Page 29
Installation
3 From the rear of the option door, position the card reader and bracket in the door such that the
card reader slot (Figure 21) is positioned on the top.
Figure 21: Dual Head Card Assembly and Card Reader Mounting Bracket
4
Secure the card reader and bracket to the door using three of the Q11677-24 screws. Leave the
fourth screw (lower left) out for securing ground cable later. Reattach the cable clamp to the
new bracket.
5 Reconnect the power/data cable to the seven-pin connector (Figure 21) on the Printed Circuit
Card (PCA) located on the left side of the dual head card assembly.
6 Insert the connector end of the ESD Ground Cable M02134A001 (Figure 22) to the two-pin
connector on the card reader PCA (Figure 21).
7 Attach the ring end of ESD Ground Cable M02134A001 (Figure 22) to the option door chassis
using the screw removed in Step 9 of “Removing the Card Reader from the Advantage Series
Unit”.
Card Reader Slot
M03311A001 Dual Head Card Assembly
Card Reader Mounting Bracket T19362-02
Printed
Circuit
Card
2 Pin
Antenna
Connector
7 Pin
Power/Data
Connector
2 Pin ESD
Ground
Connection
Refer to Figure 12 and ensure that the M02134A001 ESD Ground Cable is inserted into the
correct connector on the dual head card assembly. Failure to connect the cable properly will
damage the card reader.
CAUTION