User Manual

Installation
Page 32 MDE-4199 Contactless Smart Card Retrofit Kit M05205K00X Installation Manual • January 2005
13 Connect the M04124A004 antenna cable to the two-pin connector (Figure 21) on the Printed
Circuit Assembly located on the dual head card assembly.
14 Connect the other end of antenna cable to the 2-pin RF connector on the antenna (Figure 23).
15 Using Q13558-04 cable mounts, properly dress the cables to avoid pinching or excessive
stretching during openings and closings of either or both doors (See Figure 25).
Figure 25: Cable Properly Dressed from Antenna to Card Reader
16
Obtain the M02962B005 FCC Decal and the N23951-09 UL/CA Recognition Decal from the
kit, and from Side A of the dispenser affix the decals to the inside of the column sheathing
location on the right.
17 Repeat steps 1 through 18Eclipse Card Reader Shield if installing on Side B.
Refer to Figure 23 and Figure 24 and ensure that the Antenna Cable is inserted into the 2
PIN Antenna connector on the dual head card assembly. Failure to connect the cable
properly will damage the card reader.
CAUTION