User Manual

MDE-4199 Contactless Smart Card Retrofit Kit M05205K00X Installation Manual • January 2005 Page 7
Installation
Installation
Installing M05205K001 Kit in an Encore Unit
The M05205K001 Kit contains parts for both side 1 and side 2 of the Encore Unit. Therefore,
all procedures performed on Side 1 of the unit must also be performed on Side 2.
Removing the Card Reader from the Encore Unit
When installing a contactless smart card kit, the existing card reader must be removed and
replaced with a dual head card assembly (part of the kit).
Remove the existing card reader as follows:
1 Read all instructions before beginning and observe all safety precautions during installation.
2 Obtain approval from store manager or responsible personnel to remove unit from service.
3 Remove AC power to the unit using the station circuit breaker. Refer to MDE-3893 Encore/
Eclipse Owners Manual for details on removing system power.
4 Locate the Customer Interface Module (CIM) door, insert the key, and open the door.
5 Repeat Step 3 for side 2 of the unit.
6 From the rear of the CIM Door disconnect the cable harness or ribbon cable connection
(Figure 1) connected to the card reader.