User Manual

Installation
Page 8 MDE-4199 Contactless Smart Card Retrofit Kit M05205K00X Installation Manual • January 2005
Figure 1: Rear View of Encore CIM Door With Card Reader
7
Remove the four hex head screws (Figure 1) that secure the card reader bracket (Figure 1) and
the card reader, to the options door using 1/4-inch nut driver. Dispose of the card reader and
bracket.
Note: Make note of the card readers’ gasket orientation, this information will be useful when
installing the new M00682 card reader gasket. Also, ensure that the option door has
been cleaned with isopropyl alcohol and a clean cloth prior to installing the new
M00682 card reader gasket.
8 Remove the old card reader gasket from the options door. If necessary, use a putty knife.
Installing the Encore Dual Head Card Assembly
Perform the following procedures to install the Encore dual head card assembly.
1 Remove the adhesive backing from the M00682B001 Card Reader Gasket and place the
gasket over the card reader opening from the inside of the opened CIM door.
2 Obtain the M03311A001 Dual Head Card Assembly (Figure 2) and M01180B004 Contactless
Smart Bracket (Figure 2) from the kit, and assemble the reader and bracket for installation
onto the CIM door.
3 From the rear of the CIM door, position the card reader and bracket in the door such that the
card reader slot (Figure 2) is positioned on the top.
Cable Harness Connection
Fasteners
Fasteners