User Manual

Mounting the FlexPay Contactless Module on The Advantage Series Dispensers
P
re
l
im
i
na
ry
Page 10 MDE-4939 FlexPay™ Contactless Module Installation and Service Manual · May 2011
Mounting the FlexPay Contactless Module on The
Advantage Series Dispensers
<<Please provide the part number for the parts used in this procedure.>>
To mount the FlexPay Contactless Module on The Advantage Series Dispensers, proceed as
follows:
1 Remove the existing Contactless Reader, if present.
2 Assemble the Bracket and the OTI Module using the four screws, the four nylon washers, and
the four nuts provided in the kit as shown in
Figure 8.
Figure 8: Bracket and OTI Module Assembly
3 Mount the assembled bracket and the OTI Module on the dispenser using the three screws
provided in the kit as shown in
Figure 9.
Figure 9: Mounting the Assembled Bracket on the Dispenser
<<Dave Rowe’s comment: “Is there a spot on the door already for this? I really can’t tell how
this attaches to the dispenser door.”. Please clarify.>>
Screws