User Manual
Table Of Contents
- Manual Cover.pdf
- MDE-4939 Preliminary 050511.pdf
- FlexPay™ Contactless Module Installation and Service Manual
- Introduction
- Important Safety Information
- Mounting the FlexPay Contactless Module on Encore S Enhanced Dispenser Equipped with SPOT EMV CRIND
- Mounting the FlexPay Contactless Module on The Advantage Series Dispensers
- Mounting the FlexPay Contactless Module on Encore 300 and Encore 500 Dispensers
- Mounting the Contactless OTI Module on Encore 300 (Pre-EMV) Dispensers
- Mounting the FlexPay Contactless Module on Encore 500 S Dispensers
- Mounting the FlexPay Contactless Module on Eclipse Dispensers
- Mounting the FlexPay Contactless Module on FlexPay OPT Dispensers
- Installing the Contactless Interface Board on SCR 2
- Configuring SPOT EMV CRIND for FlexPay Contactless Module
- Verifying Functionality of FlexPay Contactless Module Through CRIND Diagnostics (Generic CRIND)
- Affixing FlexPay Contactless FCC Label
- FlexPay™ Contactless Module Installation and Service Manual
MDE-4939 FlexPay™ Contactless Module Installation and Service Manual · May 2011 Page 11
Mounting the FlexPay Contactless Module on Encore 300 and Encore 500 Dispensers
Pr
e
li
m
in
a
ry
Mounting the FlexPay Contactless Module on Encore 300
and Encore 500 Dispensers
<<Please provide the part numbers for the parts used in this procedure.>>
To mount the FlexPay Contactless Module on Encore 300 and Encore 500 Dispensers, proceed
as follows:
1 Remove the existing Contactless Reader, if present.
2 Assemble the Bracket, the Spacer, and the OTI Module using the four screws, the four nylon
washers, and the four nuts provided in the kit (see
Figure 10).
Figure 10: Bracket and OTI Module Assembly
OTI Module
Spacer
Bracket
Screws (4X)
3 Mount the assembled bracket, the Spacer, and the OTI Module on the dispenser using the
screws provided in the kit (see
Figure 11).
Figure 11: Mounting the Assembled Bracket on the Dispenser
Assembled
Bracket