User Manual
Table Of Contents
- Manual Cover.pdf
- MDE-4939 Preliminary 050511.pdf
- FlexPay™ Contactless Module Installation and Service Manual
- Introduction
- Important Safety Information
- Mounting the FlexPay Contactless Module on Encore S Enhanced Dispenser Equipped with SPOT EMV CRIND
- Mounting the FlexPay Contactless Module on The Advantage Series Dispensers
- Mounting the FlexPay Contactless Module on Encore 300 and Encore 500 Dispensers
- Mounting the Contactless OTI Module on Encore 300 (Pre-EMV) Dispensers
- Mounting the FlexPay Contactless Module on Encore 500 S Dispensers
- Mounting the FlexPay Contactless Module on Eclipse Dispensers
- Mounting the FlexPay Contactless Module on FlexPay OPT Dispensers
- Installing the Contactless Interface Board on SCR 2
- Configuring SPOT EMV CRIND for FlexPay Contactless Module
- Verifying Functionality of FlexPay Contactless Module Through CRIND Diagnostics (Generic CRIND)
- Affixing FlexPay Contactless FCC Label
- FlexPay™ Contactless Module Installation and Service Manual
Mounting the Contactless OTI Module on Encore 300 (Pre-EMV) Dispensers
P
re
l
im
i
na
ry
Page 12 MDE-4939 FlexPay™ Contactless Module Installation and Service Manual · May 2011
Mounting the Contactless OTI Module on Encore 300
(Pre-EMV) Dispensers
<<Please provide the required information.>>
Mounting the FlexPay Contactless Module on Encore 500 S
Dispensers
<<Please provide the part numbers for the parts used in this procedure.>>
To mount the FlexPay Contactless Module on Encore 500 S Dispensers, proceed as follows:
1 Remove the existing Contactless Reader, if present.
2 Assemble the Bracket, the Spacer, and the OTI Module using the four screws, the four nylon
washers, and the four nuts provided in the kit (see
Figure 12).
Figure 12: Bracket and OTI Module Assembly
OTI Module
Spacer
Bracket
Washer
Nut
Screws (4X)