User Manual

Mounting the FlexPay Contactless Module on FlexPay OPT Dispensers
P
re
l
im
i
na
ry
Page 14 MDE-4939 FlexPay™ Contactless Module Installation and Service Manual · May 2011
3 Mount the assembled bracket and the OTI Module on the dispenser using the three screws
provided in the kit (see
Figure 15).
Figure 15: Mounting the Assembled Bracket on the Dispenser
Assembled
Bracket
Mounting the FlexPay Contactless Module on FlexPay OPT
Dispensers
<<Please provide the required information.>>
Installing the Contactless Interface Board on SCR 2
To install the Contactless Card Communication option on the M10728B001 or the
M10728B002 SCR2 Assembly, proceed as follows:
1 Use a Phillips screwdriver (size 1) and remove the screw that secures the Hex standoff to the
upper flange of the SCR (see
Figure 16).
Figure 16: Removing the Screw from the Hex Standoff