User Manual
Table Of Contents
- Manual Cover.pdf
- MDE-4939 Preliminary 050511.pdf
- FlexPay™ Contactless Module Installation and Service Manual
- Introduction
- Important Safety Information
- Mounting the FlexPay Contactless Module on Encore S Enhanced Dispenser Equipped with SPOT EMV CRIND
- Mounting the FlexPay Contactless Module on The Advantage Series Dispensers
- Mounting the FlexPay Contactless Module on Encore 300 and Encore 500 Dispensers
- Mounting the Contactless OTI Module on Encore 300 (Pre-EMV) Dispensers
- Mounting the FlexPay Contactless Module on Encore 500 S Dispensers
- Mounting the FlexPay Contactless Module on Eclipse Dispensers
- Mounting the FlexPay Contactless Module on FlexPay OPT Dispensers
- Installing the Contactless Interface Board on SCR 2
- Configuring SPOT EMV CRIND for FlexPay Contactless Module
- Verifying Functionality of FlexPay Contactless Module Through CRIND Diagnostics (Generic CRIND)
- Affixing FlexPay Contactless FCC Label
- FlexPay™ Contactless Module Installation and Service Manual
Installing the Contactless Interface Board on SCR 2
P
re
l
im
i
na
ry
Page 18 MDE-4939 FlexPay™ Contactless Module Installation and Service Manual · May 2011
Connecting the OTI Module to the Contactless Interface Board
Connect the OTI Module to the Contactless Interface Board as shown in Figure 20.
Figure 20: Connecting the OTI Module
OTI Module
Connecting Power to the Contactless Communication Board
Connect the Power Cable to the Contactless Communication Board as shown in Figure 21.
Figure 21: Connecting Power Cable to the Contactless Communication Board
Power Cable