User Manual
Table Of Contents
- Manual Cover.pdf
- MDE-4939 Preliminary 050511.pdf
- FlexPay™ Contactless Module Installation and Service Manual
- Introduction
- Important Safety Information
- Mounting the FlexPay Contactless Module on Encore S Enhanced Dispenser Equipped with SPOT EMV CRIND
- Mounting the FlexPay Contactless Module on The Advantage Series Dispensers
- Mounting the FlexPay Contactless Module on Encore 300 and Encore 500 Dispensers
- Mounting the Contactless OTI Module on Encore 300 (Pre-EMV) Dispensers
- Mounting the FlexPay Contactless Module on Encore 500 S Dispensers
- Mounting the FlexPay Contactless Module on Eclipse Dispensers
- Mounting the FlexPay Contactless Module on FlexPay OPT Dispensers
- Installing the Contactless Interface Board on SCR 2
- Configuring SPOT EMV CRIND for FlexPay Contactless Module
- Verifying Functionality of FlexPay Contactless Module Through CRIND Diagnostics (Generic CRIND)
- Affixing FlexPay Contactless FCC Label
- FlexPay™ Contactless Module Installation and Service Manual
Configuring SPOT EMV CRIND for FlexPay Contactless Module
P
re
l
im
i
na
ry
Page 20 MDE-4939 FlexPay™ Contactless Module Installation and Service Manual · May 2011
3 Enter the right-most six digits of the PPN and press ENTER/OK. The Service Menu - Main
Menu is displayed (see
Figure 24).
Note: If you do not enter the password within 60 seconds, the unit automatically restarts.
Figure 24: Service Menu - Main Menu
4 Press 3. The System Configuration Menu is displayed as shown in Figure 26.
Figure 25: System Configuration Menu