User Manual
Table Of Contents
- Manual Cover.pdf
- MDE-4939 Preliminary 050511.pdf
- FlexPay™ Contactless Module Installation and Service Manual
- Introduction
- Important Safety Information
- Mounting the FlexPay Contactless Module on Encore S Enhanced Dispenser Equipped with SPOT EMV CRIND
- Mounting the FlexPay Contactless Module on The Advantage Series Dispensers
- Mounting the FlexPay Contactless Module on Encore 300 and Encore 500 Dispensers
- Mounting the Contactless OTI Module on Encore 300 (Pre-EMV) Dispensers
- Mounting the FlexPay Contactless Module on Encore 500 S Dispensers
- Mounting the FlexPay Contactless Module on Eclipse Dispensers
- Mounting the FlexPay Contactless Module on FlexPay OPT Dispensers
- Installing the Contactless Interface Board on SCR 2
- Configuring SPOT EMV CRIND for FlexPay Contactless Module
- Verifying Functionality of FlexPay Contactless Module Through CRIND Diagnostics (Generic CRIND)
- Affixing FlexPay Contactless FCC Label
- FlexPay™ Contactless Module Installation and Service Manual
MDE-4939 FlexPay™ Contactless Module Installation and Service Manual · May 2011 Page 21
Configuring SPOT EMV CRIND for FlexPay Contactless Module
Pr
e
li
m
in
a
ry
5 Press 2 to change Contactless Card Reader to OTI (see Figure 26).
Figure 26: System Configuration Menu - Contactless Card Reader Select
6 Press OK to save the changes and exit. The display goes back to the Service Menu
(see Figure 27).
Figure 27: Service Menu
7 Press Cancel. The SPOT EMV CRIND restarts.