User Manual
Table Of Contents
- Introduction
- Parts Lists
- Important Safety Information
- Preliminary Precautions
- Safety Symbols and Warning Words
- Prevent Explosions and Fires
- Prevent Electrical Shock and Sparks
- Hydraulic Pressure Releases and Fuel Leakage
- Protect Your Eyes
- React Quickly to Fuel Spills, Fires or Vehicle Impact
- Emergency and First Aid Information
- Warning Labels
- Working Alone
- Contacting Emergency Personnel
- Informing Emergency Personnel
- Other Useful Safety Information
- Classifying Hazardous Locations
- ASC TRIND Technology Update
- Installation Instructions For The Advantage Series Units
- Important Preinstallation Instruction.
- Removing Mobil Logo Display Cabinet
- Preparing For Installation
- Modifying Right Options Door
- Reinstalling Button
- Reinstalling Door Alarm Switches
- Installing Right Options Door
- Installing Bulkhead Grommet
- Installing Card Cage Assembly
- Installing Transmitter Cables
- Routing R20773-G2 Cables
- T20662-G2 Cable Routing In Main Cabinet
- Installation Instructions For MPD-3 Units
- Preparing Antenna Cable Connections
- CRIND® BIOS TRIND™ TIRIS Upgrade
- Dispenser Set-Up
Installation Instructions For The Advantage Series Units
Page 26 MDE-4063 TRIND TIRIS Retrofit Kit C00011-010-XXXX Installation Manual
• August 2001
P
r
e
liminary
08-2
4
-01
For 36" units with stop or call buttons previously installed, perform the
following steps.
Remove all hardware from new right options door according to the following steps and save
all parts for reassembly.
• Remove two screws mounting door shield on rear of door.
• Disconnect cable R20522-G2 from light/microreader printed circuit board (PCB) by
disconnecting J181 on cable from P181 on board.
• Remove Light/Microreader PCB.
• Remove screws and antenna board.
• Remove display PCB
For all units, do the following:
1 Mark placement of pump stop or call button on new right options door by measuring from
door edges as shown.
2 Away from fuel island, drill a 7/8 inch diameter hole in the location shown above. Remove any
burrs around hole with deburring tool or rounded file.
Door
shield
Antenna PCB
T20524
Light/Microreader
PCB T20601
Clear door assembly
Display PCB
1
9
/
16
"
3
3
/
16
"
Hole location for pump stop or call button
10
1
/
64
"
8
13
/
16
"
Wide Frame
Door measured
from front
Narrow Frame
Door measured
from rear