User Manual
Table Of Contents
- Introduction
- Parts Lists
- Important Safety Information
- Preliminary Precautions
- Safety Symbols and Warning Words
- Prevent Explosions and Fires
- Prevent Electrical Shock and Sparks
- Hydraulic Pressure Releases and Fuel Leakage
- Protect Your Eyes
- React Quickly to Fuel Spills, Fires or Vehicle Impact
- Emergency and First Aid Information
- Warning Labels
- Working Alone
- Contacting Emergency Personnel
- Informing Emergency Personnel
- Other Useful Safety Information
- Classifying Hazardous Locations
- ASC TRIND Technology Update
- Installation Instructions For The Advantage Series Units
- Important Preinstallation Instruction.
- Removing Mobil Logo Display Cabinet
- Preparing For Installation
- Modifying Right Options Door
- Reinstalling Button
- Reinstalling Door Alarm Switches
- Installing Right Options Door
- Installing Bulkhead Grommet
- Installing Card Cage Assembly
- Installing Transmitter Cables
- Routing R20773-G2 Cables
- T20662-G2 Cable Routing In Main Cabinet
- Installation Instructions For MPD-3 Units
- Preparing Antenna Cable Connections
- CRIND® BIOS TRIND™ TIRIS Upgrade
- Dispenser Set-Up
MDE-4063 TRIND TIRIS Retrofit Kit C00011-010-XXXX Installation Manual• August 2001 Page 43
Installation Instructions For MPD-3 Units
Preliminary
0
8-2
4-01
Routing Cables into Main Cabinet
1 Open bezel doors on main cabinet.
2 Locate indent on rear of door behind 3/4" diameter unopened access point.
3 Use 3/4" drill bit to open hole in plastic door from rear of door.
Note: If electric drill is used work must be 20’ from fuel island.
4 Use deburring tool or file to round edges of hole.
5 On left side of main cabinet (viewed from ‘A’ side), in center bottom of wrapper, use snips to
cut two 3/8" slits at 45 degree angle.
Note: Slots and folds duplicate those done on inner sheathing. See illustration on page 41.
6 Fold pieces out from cabinet and press flat against wrapper from outside.
7 Carefully return cabinet to unit, and lower cabinet on to studs.
8 Feed cables up into cabinet under slot made in wrapper.
9 Secure cabinet in place with nuts and washers removed with cabinet.
10 Heavily seal around cable entry slot with RTV sealant from inside cabinet.
11 Reconnect barrel connectors.
Center of left side
wrapper, slotted for
cable feed
Reinstalling main
cabinet