User Manual
Table Of Contents
- Introduction
- Parts Lists
- Important Safety Information
- Preliminary Precautions
- Safety Symbols and Warning Words
- Prevent Explosions and Fires
- Prevent Electrical Shock and Sparks
- Hydraulic Pressure Releases and Fuel Leakage
- Protect Your Eyes
- React Quickly to Fuel Spills, Fires or Vehicle Impact
- Emergency and First Aid Information
- Warning Labels
- Working Alone
- Contacting Emergency Personnel
- Informing Emergency Personnel
- Other Useful Safety Information
- Classifying Hazardous Locations
- ASC TRIND Technology Update
- Installation Instructions For The Advantage Series Units
- Important Preinstallation Instruction.
- Removing Mobil Logo Display Cabinet
- Preparing For Installation
- Modifying Right Options Door
- Reinstalling Button
- Reinstalling Door Alarm Switches
- Installing Right Options Door
- Installing Bulkhead Grommet
- Installing Card Cage Assembly
- Installing Transmitter Cables
- Routing R20773-G2 Cables
- T20662-G2 Cable Routing In Main Cabinet
- Installation Instructions For MPD-3 Units
- Preparing Antenna Cable Connections
- CRIND® BIOS TRIND™ TIRIS Upgrade
- Dispenser Set-Up
Installation Instructions For MPD-3 Units
Page 46 MDE-4063 TRIND TIRIS Retrofit Kit C00011-010-XXXX Installation Manual
• August 2001
P
r
e
liminary
08-2
4
-01
Installing TRIND Faceplate Assembly.
Perform the following steps for each side of unit.
For installing TRIND slide-in faceplates on PMI bezels, do the following:
1 Remove new TRIND faceplate assembly from box. For ‘B’ side faceplates only, feed faceplate
cables back into faceplate housing through round hole in shield to shorten cable leads.
Note: ‘B’ side cables have a shorter run to card cage than ‘A’ side.
2 Peel adhesive backing off round gasket N23881-01. Install gasket adhesive side first to sheet
metal shield on back of faceplate to form seal around hole for cables on faceplate assembly.
3 Peel paper backing off adhesive strip on rectangular locking plate N23873-G1 and install plate
along top lip of manager keypad recess.This plate provides a bearing surface for lock cam on
new TRIND faceplate.
4 Feed ends of cables R20773-G2 through 3/4 inch hole on bezel door drilled in Step 3 of
“Routing Cables into Main Cabinet” on page 43. Pull slack cable through hole.
5 Follow these directions to install new TRIND faceplate:
• Feed top edge of faceplate in to groove on top of door.
• Gently push bottom of faceplate in until faceplate drops into bottom groove.
Note: Faceplate may be tight fit. If needed, with faceplate forced up into top groove, firmly hit
faceplate along bottom edge with palm of hand until faceplate is in bottom groove.
• Secure in place with keylock.
6 Refer to MDE-2620, Graphics Panel Application for instructions on installing graphics.
For installing TRIND™ bolt-on (stud type) faceplates, do the following:
1 Remove new TRIND faceplate assembly from box. For ‘B’ side faceplates only, feed faceplate
cables R20773-G2 back into faceplate housing through round hole in shield to shorten cable
leads.
Note: ‘B’ side cables have a shorter run to card cage than ‘A’ side.
2 Remove existing manager keypad from bezel door, and use putty knife to remove keypad
gasket and adhesive residue from door.
3 Replace the door gasket removed in step 2 with adhesive backed gasket Q11659-01.
Locking plate N23873-G1
with adhesive backing
Installing
locking
plate