User Manual
Table Of Contents
- Introduction
- Parts Lists
- Important Safety Information
- Preliminary Precautions
- Safety Symbols and Warning Words
- Prevent Explosions and Fires
- Prevent Electrical Shock and Sparks
- Hydraulic Pressure Releases and Fuel Leakage
- Protect Your Eyes
- React Quickly to Fuel Spills, Fires or Vehicle Impact
- Emergency and First Aid Information
- Warning Labels
- Working Alone
- Contacting Emergency Personnel
- Informing Emergency Personnel
- Other Useful Safety Information
- Classifying Hazardous Locations
- ASC TRIND Technology Update
- Installation Instructions For The Advantage Series Units
- Important Preinstallation Instruction.
- Removing Mobil Logo Display Cabinet
- Preparing For Installation
- Modifying Right Options Door
- Reinstalling Button
- Reinstalling Door Alarm Switches
- Installing Right Options Door
- Installing Bulkhead Grommet
- Installing Card Cage Assembly
- Installing Transmitter Cables
- Routing R20773-G2 Cables
- T20662-G2 Cable Routing In Main Cabinet
- Installation Instructions For MPD-3 Units
- Preparing Antenna Cable Connections
- CRIND® BIOS TRIND™ TIRIS Upgrade
- Dispenser Set-Up
MDE-4063 TRIND TIRIS Retrofit Kit C00011-010-XXXX Installation Manual• August 2001 Page 49
Preparing Antenna Cable Connections
Preliminary
0
8-2
4-01
Preparing Antenna Cable Connections
For all units, gain access to upper housing from underside, by removing upper housing bottom
sheathing or VaporVac belly pan, as required. Refer to MDE-2531 Service Manual for
instructions. Save all parts and hardware for reassembly. For
For additional information refer to “Cable Block Diagram R20762” on page 60 and “Cabinet
Cable Connections” on page 61.
Do the following:
1 Locate previously installed P1A/B and P3A/B ends (4 total) of cables on cable harness
M00878A002 in upper housing.
2 Be sure that all connectors can be identified for A and B sides, respectively.
Upper Housing Connections
Do the following to connect M00878A002 cable harness assembly to antenna:
1 For A Side, inside upper housing:
• Connect P1A on harness to J1 low frequency antenna cable.
• Connect P3A on harness to J2 high frequency antenna cable.
2 For B Side, inside upper housing:
• Connect P1B on harness to J1 low frequency antenna cable.
• Connect P3B on harness to J2 high frequency antenna cable.
3 Use tie wraps supplied with kit to secure cables to frame in upper housing, away from
maintenance access areas for piping and valves.
M00878A002 Cable Assembly
PB
P2B
P2A
PA
P1B
P3B
P3A
P1A