User Manual
Table Of Contents
- Introduction
- Parts Lists
- Important Safety Information
- Preliminary Precautions
- Safety Symbols and Warning Words
- Prevent Explosions and Fires
- Prevent Electrical Shock and Sparks
- Hydraulic Pressure Releases and Fuel Leakage
- Protect Your Eyes
- React Quickly to Fuel Spills, Fires or Vehicle Impact
- Emergency and First Aid Information
- Warning Labels
- Working Alone
- Contacting Emergency Personnel
- Informing Emergency Personnel
- Other Useful Safety Information
- Classifying Hazardous Locations
- ASC TRIND Technology Update
- Installation Instructions For The Advantage Series Units
- Important Preinstallation Instruction.
- Removing Mobil Logo Display Cabinet
- Preparing For Installation
- Modifying Right Options Door
- Reinstalling Button
- Reinstalling Door Alarm Switches
- Installing Right Options Door
- Installing Bulkhead Grommet
- Installing Card Cage Assembly
- Installing Transmitter Cables
- Routing R20773-G2 Cables
- T20662-G2 Cable Routing In Main Cabinet
- Installation Instructions For MPD-3 Units
- Preparing Antenna Cable Connections
- CRIND® BIOS TRIND™ TIRIS Upgrade
- Dispenser Set-Up
MDE-4063 TRIND TIRIS Retrofit Kit C00011-010-XXXX Installation Manual• August 2001 Page 57
Preparing Antenna Cable Connections
Preliminary
0
8-2
4-01
Installing Cables to Overhead Antennas
Cables should be separated into pairs for ‘A’ and ‘B’ side as instructed in ‘Installing
Transmitter Cables’ on page 32.
1 Pull ‘A’ or ‘B’ side cables, one each R20509-G2 and Q13578-01, back through hole on
antenna bracket T20211-01 onto top of unit.
2 Thread one end of plastic conduit Q13592-02 onto large threaded end of connector Q13591-01
until plastic conduit bottoms out. See Figure 17.
3 Discarding ferrule, feed pair of cables through female thread locking nut of Q13591-01
connector from non-threading side, and through hole on antenna bracket. Push other end of
plastic conduit over female thread port on connection box.
4 Feed cables through Q13591-01 connector and plastic conduit into antenna connection box.
Note: Feed sufficient length of Q13578-01 cable to exit antenna connection box and reach
connector J1 on high frequency antenna.
5 Push small male thread side of connector through hole in antenna bracket, and secure
connector with connector nut from other side of bracket (ferrule not needed).
Note: Be sure that flats of hex connector Q13591-01 are straight up and down on sides, or top
cover will not fit over at installation.
6 If using brass connector Q13591-01, cover exposed brass with black vinyl electric tape.
7 In antenna assembly connection box, connect P1 on cable R20509-G2 to J1 on low frequency
antenna board.
8 Allow co-ax cable Q13578-01 to exit antenna connection box through box cover opening, and
connect P1 on co-ax cable to J1 on high frequency antenna using co-axial cable tool Q13628-
01 found in the ASC TRIND tool kit. Do not overtighten co-axial cable.
Note: Do not replace connection box cover at this time.
Figure 17: Antenna assembly and antenna cables seen from above
Plastic conduit
(Q13592-02)
One each Q13578-01
and R20509-G2 cable
‘A’ or ‘B’ side
Connector (Q13591-01)
locking nut, female thread
Connector (Q13591-01),
male thread, both ends
Female thread port on antenna
assembly connection box
High frequency antenna: J1
connection on far side - not shown