User Manual
Table Of Contents
- Introduction
- Parts Lists
- Important Safety Information
- Preliminary Precautions
- Safety Symbols and Warning Words
- Prevent Explosions and Fires
- Prevent Electrical Shock and Sparks
- Hydraulic Pressure Releases and Fuel Leakage
- Protect Your Eyes
- React Quickly to Fuel Spills, Fires or Vehicle Impact
- Emergency and First Aid Information
- Warning Labels
- Working Alone
- Contacting Emergency Personnel
- Informing Emergency Personnel
- Other Useful Safety Information
- Classifying Hazardous Locations
- ASC TRIND Technology Update
- Installation Instructions For The Advantage Series Units
- Important Preinstallation Instruction.
- Removing Mobil Logo Display Cabinet
- Preparing For Installation
- Modifying Right Options Door
- Reinstalling Button
- Reinstalling Door Alarm Switches
- Installing Right Options Door
- Installing Bulkhead Grommet
- Installing Card Cage Assembly
- Installing Transmitter Cables
- Routing R20773-G2 Cables
- T20662-G2 Cable Routing In Main Cabinet
- Installation Instructions For MPD-3 Units
- Preparing Antenna Cable Connections
- CRIND® BIOS TRIND™ TIRIS Upgrade
- Dispenser Set-Up
MDE-4063 TRIND TIRIS Retrofit Kit C00011-010-XXXX Installation Manual• August 2001 Page 63
CRIND® BIOS TRIND™ TIRIS Upgrade
Preliminary
0
8-2
4-01
CRIND
®
BIOS TRIND™ TIRIS Upgrade
Units must have current Z-180 CRIND logic board.
Install the CRIND Bios TRIND software K93744-01, one per logic board, on the T17764-XX
CRIND logic board(s) according to the following steps.
Note: A properly grounded electrostatic discharge wrist strap must be worn during this
procedure.
U7
Chip
orientation
notch
T17764-XX
CRIND
logic board
(-G3 shown)
JP1-16