User Manual
Table Of Contents
- Introduction
- Parts Lists
- Important Safety Information
- Preliminary Precautions
- Safety Symbols and Warning Words
- Prevent Explosions and Fires
- Prevent Electrical Shock and Sparks
- Hydraulic Pressure Releases and Fuel Leakage
- Protect Your Eyes
- React Quickly to Fuel Spills, Fires or Vehicle Impact
- Emergency and First Aid Information
- Warning Labels
- Working Alone
- Contacting Emergency Personnel
- Informing Emergency Personnel
- Other Useful Safety Information
- Classifying Hazardous Locations
- ASC TRIND Technology Update
- Installation Instructions For The Advantage Series Units
- Important Preinstallation Instruction.
- Removing Mobil Logo Display Cabinet
- Preparing For Installation
- Modifying Right Options Door
- Reinstalling Button
- Reinstalling Door Alarm Switches
- Installing Right Options Door
- Installing Bulkhead Grommet
- Installing Card Cage Assembly
- Installing Transmitter Cables
- Routing R20773-G2 Cables
- T20662-G2 Cable Routing In Main Cabinet
- Installation Instructions For MPD-3 Units
- Preparing Antenna Cable Connections
- CRIND® BIOS TRIND™ TIRIS Upgrade
- Dispenser Set-Up
MDE-4063 TRIND TIRIS Retrofit Kit C00011-010-XXXX Installation Manual• August 2001 Page 67
Dispenser Set-Up
Preliminary
0
8-2
4-01
Installing Cladding Cap
Cladding caps R20554-01 (quantity of 2) are used to fill the gap between the side cladding and
logo display cabinet resulting from raising cabinet during the TRIND™ retrofit.
Perform the following steps to install each cladding cap.
1 Replace outside sheathing with side cladding still attached, using only as many screws as
necessary to hold in place temporarily.
2 Fit cladding cap R20554-01 over top of side cladding with flat piece extended on to top of logo
display cabinet. Cladding cap will extend below top edge of side cladding.
3 Using center punch and hammer, mark two mounting holes (per unit side) on side cladding
through two existing holes in cladding cap.
4 Remove outside sheathing and attached side cladding from unit, and take to a non-hazardous
location away from the fuel island.
5 Drill holes at the points marked by the center punch for self-threading screws K85736-45.
6 Re-install the outside sheathing with side cladding attached using all screws removed during
disassembly.
7 Attach cladding cap to side cladding using K85736-45 self threading black screws.
8 Proceed to “CRIND® BIOS TRIND™ TIRIS Upgrade” on page 63.
CAUTION
If power tools are used for
assembly work must be
done at least 20" from fuel
island
Figure 20: Installing cladding cap
Pre-drilled holes for mounting
cladding cap to top of outside
sheathing with K85736-45
screws
Flat extension sits on
top of logo display
cabinet