User Manual
Table Of Contents
- Introduction
- Parts Lists
- Important Safety Information
- Preliminary Precautions
- Safety Symbols and Warning Words
- Prevent Explosions and Fires
- Prevent Electrical Shock and Sparks
- Hydraulic Pressure Releases and Fuel Leakage
- Protect Your Eyes
- React Quickly to Fuel Spills, Fires or Vehicle Impact
- Emergency and First Aid Information
- Warning Labels
- Working Alone
- Contacting Emergency Personnel
- Informing Emergency Personnel
- Other Useful Safety Information
- Classifying Hazardous Locations
- ASC TRIND Technology Update
- Installation Instructions For The Advantage Series Units
- Important Preinstallation Instruction.
- Removing Mobil Logo Display Cabinet
- Preparing For Installation
- Modifying Right Options Door
- Reinstalling Button
- Reinstalling Door Alarm Switches
- Installing Right Options Door
- Installing Bulkhead Grommet
- Installing Card Cage Assembly
- Installing Transmitter Cables
- Routing R20773-G2 Cables
- T20662-G2 Cable Routing In Main Cabinet
- Installation Instructions For MPD-3 Units
- Preparing Antenna Cable Connections
- CRIND® BIOS TRIND™ TIRIS Upgrade
- Dispenser Set-Up
MDE-4063 TRIND TIRIS Retrofit Kit C00011-010-XXXX Installation Manual• August 2001 Page 71
Dispenser Set-Up
Preliminary
0
8-2
4-01
Re-installing Logo Display Cabinet
Note: Logo display cabinet weighs approximately 75 lbs. Two people are required to perform
steps 1 through 3.
1 Carefully lift and place logo display cabinet on top of unit so that it rests on the four threaded
rods N23880-01.
2 With logo display cabinet carefully held in place, feed lighting wires on top cover up into
cabinet.
3 With wires fed into cabinet, carefully lower cabinet over threaded rods and conduit nipple until
cabinet rests securely on top cover, taking care that wires are not crushed by cabinet.
4 Remove two threaded rods from opposite corners.
5 Secure logo display cabinet to unit top using two of four Q12617-04 bolts, 3" long, and lock
washers, flat washers and soft aluminum washers removed in Step 5 of ‘Removing Mobil
Logo Display Cabinet’ on page 22, through two mounting holes without threaded rods.
6 With logo display secured, remove remaining two threaded rods and replace with remaining
two Q12617-04 bolts, soft aluminum washers, flat washers and lock washers. Keep threaded
rods for other installations.
Note: Return threaded rods N23880-01 to the ASC TRIND tool kit to be used for future
installations.
7 Install washer first and then locking nut on to conduit nipple extending into logo display
cabinet, and tighten.
Note: Install contractor supplied fittings (washers, locking nuts, conduit connectors, etc.) as
needed on conduit nipple to provide electrical connection to logo display box in
accordance with NFPA 70, The National Electric Code. Washers and locking rings
must firmly secure metal to metal surfaces of top cover and logo display cabinet at
conduit.
8 From inside of logo display cabinet seal four unused slots (1/2 inch x 5/8 inch) with RTV.
(Slots were for cladding to display cabinet fasteners.)
9 Reconnect wires disconnected in Step 2 of ‘Removing Mobil Logo Display Cabinet’ on
page 21.
10 Reinstall logo display faceplates, re-using the six screws per side removed in Step 1 of
‘Removing Mobil Logo Display Cabinet’ on page 21.
Q12616-04 bolt (3")
Lock washer
Flat washer
Soft aluminum washer
Figure 24: Logo display cabinet hardware