User Manual

Installation
Page 16 MDE-4017A Mat Reader Assembly Kit C00016-XXX Installation • September 2001
Pre
l
iminar
y
09/13/0
1
Mounting Mat Reader Interface Box
1 Determine the location for the installation of indoor equipment. The Interface Box may be
mounted under the counter top (upside down) or vertically on one of the supporting walls of
the counter top.
Note: Refer to site prep document provided by point of sale company and keep in mind overall
5-foot (1.5 meter) length of cable to connect Mat Reader Interface Box to Mat Reader.
Also refer to “In Relation to the Interface Box” on page 10.
2 Use a Zircon stud/bracket finder to ensure no electrical conduits or pipes are located inside of
wall where the Mat Reader Interface Box is to be mounted. Also, ensure the Mat Reader
Interface Box is to be located where studs or wall (concrete/brick/drywall) mollys can be used
for mounting.
3 Mark and drill holes. Insert wall mollys if required.
4 Use 8-32 thread-forming screws provided or other appropriate contractor-supplied mounting
hardware to secure the Mat Reader Interface Box to the wall or under counter top.
Note: 3/8-inch deep pilot holes (approximately 1/8-inch diameter) will be required if the
screws provided are used.
Figure:
Mat Reader Interface Box Mounting Holes
Do not use the Mat Reader Interface Box as a drill guide. It may be used as a template to
mark the holes to be drilled.
CAUTION
mounting holes