User Manual
Table Of Contents
- Introduction
- Important Safety Information
- Reference Information
- Parts Lists
- Interconnect/Block Diagrams
- Installation
- Commissioning and Warranty Information
Page 21 MDE-4017A Mat Reader Assembly Kit C00016-XXX Installation • September 2001
Installation
Pre
l
iminar
y
09/13/0
1
Figure: Connecting to Mat Reader - High Frequency
7 On unused cable channel, install plastic filler channel (M01871B002).
8 Install neoprene foam tape (M01870B002) over filler channel, ribbon cable, and coaxial cable.
Foam tape should fit snugly into cutout of surrounding foam tape backer.
9 Gently turn the Mat Reader to the face-up position.
Figure:
Mat Reader - Face Up
10 Connect the loose end of the CAT-5 cable to the POS system.
Note: For a G-SITE system, the exact G-SITE system port depends on the G-SITE system
configuration. Refer to MDE-3110 PC-Based G-SITE System Installation Manual.
7-pin cable connector
channel for ribbon cable
acrylic foam tape
ribbon cable
plastic channel filler
unused channel
neoprene foam tape
carefully connect
these
coaxial cable