User's Manual

Installation Instructions For MPD®-3 Units
Page 36 MDE-3591A TRIND
™
/TIRIS
™
Retrofit Kits C00011-002-XXXX • 11/00
PRELIMINARY
FCC 11/30
Removing Main Cabinet
1 Locate four nuts on each side of main cabinet, ‘A’ and ‘B’, that secure cabinet to
frame.
2 Remove all eight nuts and washers, and save for reassembly.
3 Disconnect barrel connectors to allow cabinet to be removed from unit.
Note: If barrel connectors are mounted to holding plate(s), remove plates and
discard.
4 Carefully lift cabinet up and off studs, and remove from fuel island.
5 Remove inner sheathing on left column (viewed from ‘A’ side). Set sheathing and
screws aside for reassembly. See illustration below.
Note: For units with VaporVac
®
, VaporVac pan does not need to be removed.
Sheathing can be carefully pulled out from center until top bends clear of
pan.
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
+
Four nuts each side, ‘A’
and ‘B’, on mounting
studs behind lip
Removing main cabinet