User's Manual

Installation Instructions For MPD®-3 Units
Page 38 MDE-3591A TRIND
™
/TIRIS
™
Retrofit Kits C00011-002-XXXX • 11/00
PRELIMINARY
FCC 11/30
5 Loop cables below hole and back up through hole and out of column.
6 Feed cable ends into vapor barrier, dressing and securing cables in place with
electrical tape.
7 Away from island, use snips or shears to cut slits 1-1/2" apart in bottom center of
inside sheathing at 45 degree angles. See illustration below.
8 Fold pieces forward on cabinet side of sheathing. Use hammer to flatten folded
pieces as shown.
9 Reposition inner sheathing and tape in place, being sure that cables pass through
opening at bottom.
10 Replace outside sheathing, and remove tape from inner sheathing.
11 Dress and secure cables on cabinet top with electrical tape.
Notching inner sheathing
Step 7:
Cut two slits 3/8"
deep at 45 degree
angle approximately
1 1/2" apart in
bottom center of
sheathing
Step 8: Use pliers to fold pieces in direction of cabinet
and away from column. Use hammer to flatten
Finished inner
sheathing - side
facing main cabinet