User's Manual

MDE-3591A TRIND
™
/TIRIS
™
Retrofit Kits C00011-002-XXXX • 11/00 Page 47
Instructions for All Units
PRELIMINARY
FCC 11/30
Do the following:
1 For brackets attached to cable side of antenna assembly, be sure that cables are
contained in raised bracket channel.
2 For all brackets, with or without cables, position rubber washer, metal washer
and lifting bracket removed in “Preparing For Installation” on page 19 over
bracket mounting hole.
3 Secure with bolt removed in “Preparing For Installation” on page 19. Repeat for
all brackets and sides.
4 Proceed to “Sealing Antenna Bracket with Cables on All Units” on page 49.
For Units With Exxon Light Boxes
Do the following:
1 Place assembled antenna and bracket (as completed in “For All Units” on page 45)
on A or B side of top of Light Box, as shown.
2 Center assembly by measuring equal distances from each end of Light Box.
3 Use center punch to mark centers of three mounting holes per bracket.
4 For bracket side with antenna cables only, place a mark on Light Box top at
center of cable channel.
Note: Cables will always be on the left side of antenna assembly when facing unit.
Measurement
from near side
of bracket to
edge of Light
Box = X
Measurement
from near side
of bracket to
edge of Light
Box = X
bracket mounting holes
mark at center of raised
channel
long side of Light Box
short side of Light Box
6 3/4’’