User Manual

E) Auto Ease-In:
If using a v1.1 AutoDownload file generated with Pc•MACs version
2.02.212.xxx or later, this will be set automatically for you from data in the
AutoDownload file.
When enabled, this feature will keep all the selected channels from jump-
ing at a high rate of speed if:
1) Incoming frame number received through the 'Smart' BrickNet
jumps more than five frames. (This is typically caused by dis-
continuous time code being received by the 'Smart' Brick Brain,
or when the 'Smart' Brick Brain jumps to a different show.)
2) The DMX-512 data starts being received.
3) The DMX-512 signal drops out for more than a second.
4) An output is forced to a specific value.
5) One or more outputs are put into or taken out of the internal
test mode.
6) At boot up as the outputs assume their default values.
This command allows you to select the amount of time any output will
take to ramp from one extreme to the other and which outputs will be using
the Ease-In feature. The range of time available is:
1) Ease-In is disabled
2) ¼ second
3) ½ second
4) ¾ second
5) 1 second
6) 1-½ seconds
7) 2 seconds
8) 2-½ seconds
9) 3 seconds
10) 4 seconds
11) 5 seconds
12) 6 seconds
13) 7 seconds
14) 8 seconds
15) 9 seconds
16) 10 seconds
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax [phone]
Br-ANA Manual / December 18, 2012 10:21 AM / page 36 of 60