User Manual

1) Showʼs numeric position in the AutoDownload file
2) Showʼs ʻshortʼ (DOS 8.3) name
3) Offset to the ʻstartʼ of the show
4) Length of the show (in frames)
5) Under the ʻSʼ, whether the show is
1) ʻSteppableʼ (interruptible if a new show request arrives while this
show is playing) is shown by a ʻYʼ
2) ʻnon-Steppableʼ (uninterruptible if a new show request arrives
while this show is playing) is shown by a ʻNʼ
6) Under the ʻLʼ, whether the show is
1) ʻLoopableʼ (Plays to the end of the show, then performs the ʻat
endʼ actions as set on the AutoDownload dialog) is shown by a
ʻYʼ
2) ʻnon-Loopableʼ (Plays to the end of the show, and stops and
waits for the next start command) is shown by a ʻNʼ
7) The frame rate for the show
8) The ʻnextʼ show defined for the show during the AutoDownload
o) the current output level of each analog/ServoMotor output:
O) Reload Defaults:
This command sets all the settings of the Br-ANA back to factory defaults.
It asks you an extra time if you are really sure you want to do this before it
does.
P) Play/Loop:
If operating as a ʻDumbʼ Brick, allows you to select and play a show.
H) Halt:
If operating as a ʻDumbʼ Brick, allows you to stop the currently playing
show.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax [phone]
Br-ANA Manual / December 18, 2012 10:21 AM / page 44 of 60