User Manual

R) Save Configs:
This command is used to save the current configuration of the Br-ANA
through the serial port to a file on your computer. This file can then be re-
loaded into this, or any other Br-ANA. To use this command, you first invoke
it, then following the instructions, you set your computer to receive a string of
ASCII characters.
You then press any key to tell the Br-ANA to send out it's configuration.
When it has finished, you then tell your computer to stop saving characters,
and then hit any key to tell the Br-ANA to redraw the screen.
V) Verify:
This command verifies the data stored in the Br-ANAʼs flash memory.
This will take anywhere from a few seconds to several minutes, depending
of the size of the AutoDownload file that must be tested.
Gilderfluke & Co., Inc. - BR-ANA Analog Card - version 4.10 - copyright 2012 DCM
Shows: 8, Ch: 123 @___0, ADL: AutoDownload_Filename
Serial Address- __0
__1 Show_FileName.sho looping @ frame ____1363
Set your computer to save a stream of text to a file. The file should be 1043
bytes long. To reload this card, just send this file back to this screen.
Hit any key when ready.
Stop saving text and hit any key when the data has finished.
hit <ESC>ape key to cancel-
Enter Command-
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax [phone]
Br-ANA Manual / December 18, 2012 10:21 AM / page 45 of 60