Manual

capacity of another Brick card, and need to add
almost unlimited ‘off-board’ memory storage.
3) You want to have ‘centralized’ memory storage, but
only need to run a single sequencer at one time.
Animation and lighting data is stored on the
SmartMedia Flash Card and transmitted out in a DMX-
512 and/or secondary serial data port. The serial data
can be transmitted in a number of different formats. It
has dedicated modes for controlling MIDI devices,
Moog Motion Bases, Intelix matrix mixers, Rexroth DCC
Servo cards, and more. The second serial port can be
set to operate at baud rates from 2400 baud to 115
KBaud.
1) BR-SmartMedia as a ‘Dumb’ Brick: Switch #4
must be in the ‘Dumb’ Brick position to operate as a
‘Dumb’ Brick. There should never be both ‘Smart’
and ‘Dumb’ Bricks in the same card cage.
Damage may result if there are.
A ‘Dumb’ Brick is typically used in stand alone
applications, where the show runs continuously or
when triggered by an external event. Multiple
‘Dumb’ bricks can be triggered simultaneously, but
will not be automatically synchronized as the Bricks
in a ‘Smart’ Brick system are.
This BR-SmartMedia acts just like any other
Playback-Only 'Dumb' Brick, playing animation
data from the AutoDownload file found on the
SmartMedia Flash Card. The BR-SmartMedia can
be set to start and play a show at power up, or only
play when triggered. The start trigger can come
through the four optically isolated trigger inputs, or
the RS-422 serial port. The BR-SmartMedia then
GILDERFLUKE & CO .• 205 SOUTH FLOWER STREET • BURBANK , CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX [phone]
E
AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX [phone]
3 of 81