Manual

MultiShow Mode:
The menu will appear as follows when in MultiShow mode. In this case,
decimal values have been selected for the numbers. At the top of the
screen the size of the AutoDownload file found on the SmartMedia Flash
Card (if any) is shown. If the AutoDownload file isn't found, then 'not found'
will appear in this space.
-Gilderfluke & Company - BR-SmartMedia in Multi-Show Mode - v1.22 - [c]2003 DCM-
__9 shows with 232 channels @ __0 Offset / Set FileName is CROOM1__.A00
All EEprom writes are disabled. Card Address- __0
a) numbers- decimal | b) Boot check- no | c) DMX- Tx & Rx w/CS | d) VT52- no
0) input 0: close loops __1 CRoom1_A a_______ | open not used...
1) input 1: close loops __2 CRoom1_B _b______ | open not used...
2) input 2: close loops __3 CRoom1_C __c_____ | open not used...
3) input 3: close loops __4 CRoom1_D ___d____ | open not used...
4) input 4: close loops __5 CRoom1_E ____e___ | open not used...
5) input 5: close loops __6 CRoom1_F _____f__ | open not used...
6) input 6: close loops __7 CRoom1_G ______g_ | open not used...
7) input 7: close loops __8 CRoom1_H _______h | open not used...
8) blue : close E-stops shows seq. abcdefgh | open clears E-stops seq abcdefgh
9) green : close pauses show on seq abcdefgh | open continues shows on abcdefgh
sequencer numbers: a b c d e f g h
e) Ease-In speed [in seconds]: |_0.5_|_1.0_|_2.1_|_4.2_|_8.5_|_17._|_8.5_|_4.2_|
f) PowerOn/EStops go to show # |___1_|___2_|___3_|___4_|___5_|___6_|___7_|___8_|
g) analogs to EaseIn | h) operating mode | i) Info | o) reload config.
p) Play a show | r) save config. | t) Test shows | x) eXit
Enter Command-
(Sample data: Your show data will differ from what is shown.)
a) Numbering System: This toggle is used to select between
HEXadecimal and Decimal numbering systems for display and en-
tries. When percentage is selected, all entries are still made in
Decimal numbers.
b) Boot Check: This toggle is used to tell the BR-SmartMedia to
check its inputs for changes when power is first applied to the
card. In the single sequencer modes, the AutoDownload file tells
the BR-SmartMedia what to do at startup. In the MultiShow mode,
we must tell it in this way.
If this toggle is off (‘no’), then the BR-MultiShow will simply sit
and wait for a command to come in through the serial port or
switch closure inputs before it will do anything.
GILDERFLUKE & CO .• 205 SOUTH FLOWER STREET • BURBANK , CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX [phone]
E
AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX [phone]
38 of 81