Manual

If you choose option ‘b’, then the following screen will appear:
-Gilderfluke & Company - BR-SmartMedia in Multi-Show Mode - v1.22 - [c]2003 DCM-
__9 shows with 232 channels @ __0 Offset / Set FileName is CROOM1__.A00
Card Address- __0
This will restore the EEPROM configuration from the SmartMedia card.
The backup file is saved as: CONFIG.SM
Don't remove the SmartMedia card or power this unit down while the
card access LED is lit.
Hit any key when ready.
hit <ESC>ape key to cancel-
If you now hit any key OTHER than the ‘Escape’ key, the BR-
SmartMedia will attempt to open a file named ‘CONFIG.SM’ on
the SmartMedia Flash Card. If it is found, then its contents will be
put into the configuration EEprom. Any configuration that had
been in the EEprom will be overwritten.
The ‘CONFIG.SM’ file can come from either doing a ‘configu-
ration save’ to the SmartMedia Flash Card, or a serial configura-
tion save to a file named ‘CONFIG.SM’.
p) Play: This command allows you to pick and loop any show on any
of the eight sequencers. Although there is nothing to keep you
from doing so, you should only play shows on the sequencer
upon which they are normally played. If there is already one show
playing an Ease-In will take place at the start of the new show. If
the show which was playing ‘can’t’ be stepped on, then the BR-
SmartMedia will ask you if you would like to override the lockout or
not. If the sequencer you are trying to start is in an E-Stop condi-
tion, then the BR-SmartMedia will ask you if you would like to over-
ride the E-Stop or not.
r) Download configuration: This command is used to save the cur-
GILDERFLUKE & CO .• 205 SOUTH FLOWER STREET • BURBANK , CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX [phone]
E
AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX [phone]
49 of 81