Manual

BR-SmartMedia in Moog Motion Base Modes
For a BR-SmartMedia that is in Moog 2000 DOF mode, the menu will ap-
pear as follows. At the top of the screen the size of the AutoDownload file
found on the SmartMedia Flash Card (if any) is shown. If the AutoDownload
file isn't found, then 'not found' will appear in this space
-Gilderfluke & Company - BR-SmartMedia in BR-Serial Mode - v1.22 - [c]2003 DCM-
__9 shows with 232 channels @ __0 Offset / Set FileName is CROOM1__.A00
Card Address- __0
a) DMX- Tx & Rx w/CS
b) baud rate- forced to 57.6Kbaud
c) numbering system- decimal
d) VT-52 display- no
e) EaseIn speed- 2.1 seconds
h) operating mode- Moog 2000 / DOF
q) motion base ID- 1
v) monitor channel- none
u) min/max limits- 0/32767 | heave- 6550/29000
k) analog resolutions- 12 bits
l) string trigger channel- none
m) edit strings....
w) oversampling- 2x
g) analogs to EaseIn | h) operating mode | i) Info | o) reload config.
p) Play a show | r) save config. | t) Test shows | x) eXit
Enter Command-
GILDERFLUKE & CO .• 205 SOUTH FLOWER STREET • BURBANK , CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX [phone]
E
AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX [phone]
69 of 81