Owner manual

Stopped Input. Unlike the HPU Running Input, this input is not used for any
other purpose than lighting this LED.
To help keep shows from being run when the HPU has been started by its
local Hand/Off/Auto switch, the HPU Stopped Input and HPU Running Input
signals are often routed through the ʻAutoʼ position on the switch. If the
switch isnʼt in the ʻAutoʼ position, the HPU Stopped LED and HPU Running
LED wonʼt light and the Blocking valve wonʼt be enabled.
S) Show Continue LED
(One green LED)
This LED lights to show that the Motion profile on the Smart Brick System
has been programmed with the Show Pause Reset Input inactive and that
the current show has not been paused.
When a show is paused, the Kp-300 sends a signal to the Smart Brick
Brain through its Green ʻPauseʼ Output. The Smart Brick Brain input must be
configured to pause the currently running show on a closure on this input
4
.
When a show is 'continued', the signal is dropped on the Green ʻPauseʼ
Output to the Smart Brick Brain. This input must be configured to continue
the currently running show on an opening on this input.
Once a show has been paused, the only two ways to 'continue' a show
are to:
a) Send an active signal from the Smart Brick System to the Kp-
300ʼs Show Pause Reset Input.
b) Once the condition that caused the Show Pause has been re-
moved, the operator can press the Show Continue button.
T) Show Pause LED
(One red LED)
This LED lights to show that the Motion profile on the Smart Brick System
has been programmed with the Show Pause Reset Input inactive and that
the current show has been paused by the operator pressing the Show
Pause Button or an error condition.
When a show is paused, the Kp-300 sends a signal to the Smart Brick
Brain through its Green ʻPauseʼ Output. The Smart Brick Brain input must be
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax [phone]
Kp-300 Manual / September 4, 2012 4:29 PM / page 20 of 75
4
In some applications, you may want to call up a different show using this input, instead of pausing the current show.