Owner manual

to pause the currently running show on a closure on this input
8
. When a show is
'continued', the signal is dropped on the Green ʻPauseʼ Output to the Smart Brick
Brain. This input must be configured to continue the currently running show on an
opening on this input.
Once a show has been paused, the only two ways to 'continue' a show are to:
a) Send an active signal from the Smart Brick System to the Kp-
300ʼs Show Pause Reset Input.
b) Once the condition that caused the Show Pause has been re-
moved, the operator can press the Show Continue button.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax [phone]
Kp-300 Manual / September 4, 2012 4:29 PM / page 26 of 75
8
In some applications, you may want to call up a different show using this input, instead of pausing the current show.