Owner manual

1) Green ʻPauseʼ Output from Kp-300

This output is activated when there is a Show Pause event on the Kp-300. This

event causes the Pause Buss to go active, which causes the Show Pause Buss

LED to be lit. The Green ʻPauseʼ Output from Kp-300 is used to tell the Smart

Brick Brain to initiate a Show Pause through its Green ʻPauseʼ Output. The Smart

Brick Brain input must be conﬁgured to pause the currently running show on a clo-

sure on this input

. When a show is 'continued', the signal is dropped on the

Green ʻPauseʼ Output to the Smart Brick Brain. This input must be conﬁgured to

continue the currently running show on a opening on this input.

Once a show has been paused, the only two ways to 'continue' a show are to:

a) Send an active signal from the Smart Brick System to the Kp-300ʼs

Show Pause Reset Input.

b) Once the condition that caused the Show Pause has been re-

moved, the operator can press the Show Continue button.

2) Blue ʻE-Stopʼ Output from Kp-300

This output is activated when there is an E-Stop event on the Kp-300. It is used

to tell the Smart Brick Brain to start playing the E-Stop show. The Smart Brick

Brain must be conﬁgured to select and start the E-Stop show when it receives a

closure on this input.

Gilderﬂuke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485

Kp-300 Manual / September 4, 2012 4:29 PM / page 63 of 75

In some applications, you may want to call up a different show using this input, instead of pausing the current show.