Owner's manual

for accessing the strings are from one through nine, A
through F.
If using a Pioneer LaserDisk or DVD player, use the de-
fault string ‘1’ for the Start String.
If using a Sony LaserDisk player, use the default string
‘3’ for the Start String.
If using a Panasonic LaserDisk player, use the default
string ‘5’ for the Start String.
See the section on string setups for additional details
on strings and their habits.
“u” Multi-Disk String:
If not using the LaserDisk Multiplexer, this value should
be left blank.
The Rack Smart Brick Brain can sequentially control
up to seven LaserDisk Players using the LaserDisk multi-
plexer (BS-LDMUX15 for Pioneer/Panasonic players or BS-
LDMUX25 for Sony). This attaches to the Rack Smart Brick
Brain through its relay outputs and RS-422 serial port as
shown in the following drawing. Indicator LEDs show serial
data being sent to and received from the different
LaserDisks. The serial ports on the LaserDisk Multiplexer
are at RS-232 levels. Standard fifteen (Pioneer or
Panasonic) or twenty-five pin (Sony) cables can be used
to attach the LaserDisks to it. A small twelve VAC power
supply runs the LaserDisk Multiplexer. The Rack Smart
Brick Brain’s relay outputs can not be used for any other
purpose when running multiple LaserDisk players.
The MultiDisk string will be sent to each of the
LaserDisk (or DVD) players in turn. Typically the MultiDisk
string is just a LaserStart special string character (01). This
will position all of the LaserDisks (or DVD)s to the selected
frame and pause them. Players which can’t search and
GILDERFLUKE & CO .• 205 SOUTH FLOWER STREET • BURBANK , CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX [phone]
E
AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX [phone]
91 of 178