Owner's manual

They can also be used with serially controlled devices
other than LaserDisk (or DVD) players. Valid numbers for
accessing the strings are from one through nine, A
through F. If not using the LaserDisk Multiplexer, this value
should be left blank. See the section on string setups for
additional details on strings and their habits.
“v” End String:
This command is used to select which string will be
sent at the end of a show. Although these strings are
generally used when you are running a LaserDisk (or
DVD) show, you can send them at the end of any type
of show if you so desire. They can also be used with seri-
ally controlled devices other than LaserDisk (or DVD)
players. If an entry of 0 is entered for the end string, no
string will be sent at the end of this show. Valid numbers
for accessing the strings are from one through nine, A
through F.
If using a Pioneer LaserDisk or DVD player, use the de-
fault string ‘2’ for the End String.
If using a Sony LaserDisk player, use the default string
‘3’ for the End String.
If using a Panasonic LaserDisk player, use the default
string ‘7’ for the End String.
See the section on string setups for additional details
on strings and their habits.
LaserDisk Starts:
“1” LaserDisk 1:
“2” LaserDisk 2:
“3” LaserDisk 3:
“4” LaserDisk 4:
“5” LaserDisk 5:
“6” LaserDisk 6:
GILDERFLUKE & CO .• 205 SOUTH FLOWER STREET • BURBANK , CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX [phone]
E
AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX [phone]
93 of 178