Owner's manual

the Download Configuration command.
The Rack Brain will report on the success or failure of
the configuration upload on the LCD display (if installed)
and on the screen of the computer.
If you are having trouble getting good uploads, you
can set a ‘delay between each character’ in your
modem program. This will slow the transmission down.
The settings of the Lock Counter/Timer Setup screen
are not downloaded or restored by these commands.
“$” enter Keys:
This command allows you to enter the keys to open
the lock setup screen, or unlock any lock that has been
set. If a key has not yet expired, it will be halted at its cur-
rent count and will not expire. The Smart Brick Brain will re-
port on any key that is entered, and if the key successful-
ly unlocked or or not.
If the Smart Brick Brain has been locked, then it will ask
for a password before allowing you to enter configura-
tion mode. If the password clears the lock, and there are
no other locks set, then you will enter configuration after
you then hit ‘any’ key.
“x” eXit Setup Mode:
This command is used to exit the setup mode. It is
when you exit that the Smart Brick Brain saves the check-
sums it uses to determine if the configuration has
changed. If you power down the Smart Brick Brain with-
out exiting, the Smart Brick Brain will display a ‘CS Error’
message each time it boots. To clear this, you must enter
configuration and exit again, to allow the checksum to
be calculated.
After exiting configuration for the final time, you
GILDERFLUKE & CO .• 205 SOUTH FLOWER STREET • BURBANK , CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX [phone]
E
AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX [phone]
97 of 178