Owner's manual

- Smart Brick Configuration -
The majority of the configuration for the Smart Bricks is han-
dled in the Smart Brick Brain. The exceptions to this are those
jumpers which set the size and type of memory used in each
Smart Brick, and whether or not you would like the outputs from a
Smart Brick to be disabled when ever the system is not advanc-
ing frames.
The one jumper which the Smart Bricks have on them retain
the same callout as are used in the normal Micro MACs Bricks. All
configuration is done on JP-2. The two things which Smart Bricks
must be configured for are the memory size and type and the
‘enable/disable when stopped’.
In all of the following drawings, the jumper pins are shown as
circles contained within an outline of the header assembly. Pins
which are used for a given configuration are shown as filled-in,
while those which remain hollow are not being used. The jumper
plugs (used for connecting adjacent pins)or wires (used for con-
necting pins which are not adjacent) which connect the pins are
shown as black lines. Any pin which is shown filled in with black,
but which does not have any wire or jumper plug shown on it,
must have all wires and/or jumper plugs removed from it in the
actual Smart Brick you are configuring.
GILDERFLUKE & CO .• 205 SOUTH FLOWER STREET • BURBANK , CALIFORNIA 91502 • 818/840-9484 • 800/776-5972 • FAX [phone]
E
AST COAST /FLORIDA OFFICE • 7041 GRAND NATIONAL DRIVE • SUITE 128d • ORLANDO , FL. 32819 • 407/354-5954 • FAX [phone]
10 of 178