Installation Instructions

[phone] www.gilpininc.com ©Gilpin Inc. 2011
[e-mail]
Install Your Midway™ Railing from Gilpin
Tools you will probably need:
Level Hacksaw Tape Measure Drill/driver w/bits String or chalk line
 Determine location of newel posts.
o Locate edge of flanges at least 2-1/2” from edges of platform.
o Mounting holes in flanged must be drilled to accommodate method of
securing to floor.
o Posts must be plumb. Shim if necessary with
weather resistant shim materials.
 If using Installation Spindles:
o Measure up 36” from platform on newel post.
o Measure down 1-1/8” from 36” mark
o Center Installation Spindle on post.
o Fasten Installation Spindle with top at
measured mark with included screws.
 Slide rail panel down over Installation Spindles beginning at bottom rail so top
rail rests on Installation Spindle.
 Secure rail to Installation Spindle with supplied screws on both sides of top
and bottom rails.
 If using Swivel Fitting[s] (accommodates both vertical and horizontal angles):
 Install according to instructions included with Swivel Fitting set.
 Insure connections are tight.
 Touch up scratches with Gilpin Touch Up Paint.
Panel Width (“W)
Panel Width (“W)
36”