GRAB BAR INSTALLATION INSTRUCTIONS Model No: 660 thru 667, 0360 thru 0367, 1160 thru 1167, 1560 thru 1567 and 4660 660 0360 1560 2001 CARNEGIE AVE, SANTA ANA CA 92705 (949) 417-5207 WWW.GINGERCO.
ITEMS INCLUDED MOUNTING FLANGE TOOLS REQUIRED X2 SAFETY GLASSES DRILL PHILLIPS SCREW DRIVER PEN / PENCIL #10 WOOD SCREW X6 7/64” DRILL BIT LEVEL SET GRAB BAR ASSEMBLY (BAR FROM 0360 SHOWN) X1 1/4" CARBIDE TIP DRILLBIT (if drilling through ceramic tile) STUD FINDER GNG-660 EN-2736 REV A Page 2 of 4
SAFETY WARNINGS 1.DO NOT install this equipment without first reading and understanding this instuction sheet. If you are unable to understand these Warnings and Instructions, contact a health care professional, dealer or technical personnel for assistance before attemping to install this equipment- otherwise, injury may occur. 2.After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely. 3.
Figure 1 Figure 2 wood wall stud wood wall stud top wood screw wall board wood wall stud TOP VIEW HORIZONTAL MOUNT wood wall stud wood screw NORMALLY 16” CENTER TO CENTER FRONT VIEW HORIZONTAL MOUNT wood wall stud grab bar wood wall stud wall board SIDE VIEW VERTICAL MOUNT Figure 3 wood wall stud #10 Wood Screw O-ring FRONT VIEW VERTICAL MOUNT Mounting Flange M5 Screw NORMALLY 16” CENTER TO CENTER Grab Bar Escutcheon USING GRAB BAR: 1.