Mounting and Operating Instructions Flush-mounted outdoor station with call push button 1-gang 1260 65/66/67 1271 65/66/67 Flush-mounted outdoor station with call push button 3-gang 1261 65/66/67 1272 65/66/67
Device description The flush-mounted outdoor station is part of the Gira door communication system.
Mounting Attention Installation and mounting of electrical devices may only be carried out by a qualified electrician. Do not use the sealing rings included with the TX_44 frame when installing flush-mounted inserts. The flush-mounted outdoor station is installed in two common flush-mounted panel boxes: 1.
. Insert the audio connection cable into one of the two system connectors of the speech insert. 5. Install the speech insert. 6. Place the bottom section of the TX_44 cover frame in place and attach the call push button and the speech insert to the flush-mounted inserts. 7. Clip on the frame top section and press in the Torx screws. Start-up Once all of the devices (outdoor and home stations, control unit etc.) have been installed, you can start up the door communication system.
Volume setting The volume can be set separately at each outdoor station. The volume setting must be made by two people. 1. Start programming mode at the control unit by pressing the "Systemprogr." button for 3 seconds until the yellow LED next to the button starts flashing. 2. Briefly press a previously assigned call push button at the outdoor station. 3. The second person accepts the door call at the home- station (via receiver or speech button) and starts speaking. 4.
Changing the label plates To change the label plates, the call push button cover can simply be lifted up. 1. Carefully lift up the call push button cover, e.g. with a screwdriver. 2. Change the label plate. 3. Replace the call push button cover and press on it firmly. Suitable label plates can be obtained with the optional Gira labelling software and the appropriate Gira labelling sheets.
Acceptance of guarantee The warranty is provided in accordance with statutory requirements via the specialist trade. Please submit or send faulty devices postage paid together with an error description to your responsible salesperson (specialist trade/installation company/electrical specialist trade). They will forward the devices to the Gira Service Center.
Postfach 1220 42461 Radevormwald Deutschland Tel +49 (0) 21 95 / 602 - 0 Fax +49 (0) 21 95 / 602 - 191 www.gira.de info@gira.de 10 41 03 70 22/11 Gira Giersiepen GmbH & Co.