Mounting Instructions Call push button 1-gang for flush-mounted outdoor station 1262 00, 1293 00 Call push button 3-gang for flush-mounted outdoor station 1263 00, 1294 00 Information module for flush-mounted outdoor station 1264 00, 1295 00
Device description The 1 and 3-gang call buttons for the flushmounted outdoor station and the information module are part of the Gira door communication system and are used to expand the flush-mounted outdoor station. The basic structure is presented in the example of the call push button 3-gang.
Mounting Attention Installation and mounting of electrical devices may only be carried out by a qualified electrician. Do not use the sealing rings included with the TX_44 frame when installing flushmounted inserts. The 1 and 3-gang call buttons and the information module are operated together with the outdoor station: 1. Insert the audio connection cable into a system connector of the bus coupler or speech insert of the flush-mounted outdoor station.
2. Guide the audio connection cable into the flush-mounted panel box. 3. Insert the audio connection cable into a system connector of the call push button insert. 4. Install the call push button insert. 5. Set the bottom section of the TX_44 cover frame in place and attach the central inserts to the flush-mounted inserts. 6. Clip on the frame top section and press in the Torx screws. Start-up Once you have installed all of the devices (outdoor and home stations, control unit etc.
Operation Initiating a call (ringing) Press the call push button to trigger a call tone at the assigned home station. The button press is confirmed by an additional acknowledgement tone. Switching light on/off (in conjunction with a switching actuator) Press the call push button to switch on light or another device via an assigned switching actuator. The button press is confirmed by an additional acknowledgement tone.
Changing the label plates To change the label plates, the call push button cover is simply lifted up: 1. Carefully lift up the call push button cover, e.g. with a screwdriver. 2. Change the label plate. 3. Replace the call push button cover and press on it firmly. Suitable label plates can be obtained with the optional Gira labelling software and the appropriate Gira labelling sheets.
Acceptance of guarantee The warranty is provided in accordance with statutory requirements via the specialist trade. Please submit or send faulty devices postage paid together with an error description to your responsible salesperson (specialist trade/installation company/electrical specialist trade). They will forward the devices to the Gira Service Center.
Postfach 1220 42461 Radevormwald Deutschland Tel +49 (0) 21 95 / 602 - 0 Fax +49 (0) 21 95 / 602 - 191 www.gira.de info@gira.de 10 41 03 71 19/11 Gira Giersiepen GmbH & Co.