Use and Care Manual
GPW-215_215C_227 Maintenance Instruction
■
Take out Grip (2) in counter-clockwise direction.
■
Fix Stop Spanner (56) at Gear Shaft. Then posit Disc
Spanner (57) on Disc Nut (21). Release Disc Nut by
turning Disc Spanner in counter-clockwise direction, take
out Disc Nut and Pad.
■
Take Retainer Ring (8) out with pliers (as fig. F) in order
to disassemble/replace Gear Set
■
Take out Pinion Gear (22) and fix Rotor, then Loosen
Governor Assy. in clockwise direction with 12mm open
spanner.
■ CYLINDER DISASSEMBLING
Fix Cylinder Assy. in Cylinder Disassembling Base
(832T01). Use Rotor Disassembling Shaft (218051-2) to
release Rotor in order to replace Blades (29)
■FRONT PLATE SET DISASSEMBLING
1. Place Front Set in Disassembling Base (832T06).
2. Tighten Locking Screw (A) in clockwise direction with
6mm Hex. Spanner; Tighten Screws (B) in with 4mm
Hex. Spanner. Then Front Plate Set can be separated.
3. Unscrew the Locking Screw (A) in counter-clockwise in
order to take out Ball Bearing (23)
4. Use oilstone to polish the scars cause by the above steps.
2
57
21
19
F
56
Governor Assy.
832h01
Cylinder Assy.
28
22
Rotor Disassembling Shaft
(218051-2)
Cylinder Disassembling Base
(832T01)
Cylinder Assy.
8
20
Screw (B)
Screw (B)
Locking Screw (A)
Front Bearing
Disassembling Base
(832T06)
Front Plate Set
(23,24,25)
25, 24