User's Manual

PillCam Capsule Endoscopy
202 PillCam Recorder Maintenance
PillCam Recorder DR3
The PillCam recorder DR3 cradle has the following LEDs:
To charge the PillCam recorder:
1. Plug the power cable into the cradle and plug the power cable into the wall outlet.
2. Insert the PillCam recorder into the cradle.
The bottom LED is orange when charging the battery. When the PillCam recorder is fully charged, the
bottom LED turns green.
3. Leave the PillCam recorder in its cradle until the next examination.
֠
֠֠
֠
Note
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
LED Status Battery pack is...
Green On ready for use
Yellow/
Orange
On charging
Blinking charging