User Manual
Appendix: Electrical Safety
3UHSDULQJIRUD7HVW
Before the Test Day
Fully charge the data receiver the day or night before starting a test. Charging can take
up to 5 hours.
Charging the Data Receiver
1. Ensure that the data receiver is off. If any characters appear on the display, turn off
the data receiver by simultaneously pressing the 2 buttons on the front of the unit
for approximately 5 seconds.
Caution
The data receiver must be turned off during charging. Charging the data receiver while turned on results in a
partial charge. You may lose test data.
2. When the back light dims, release both buttons.
3. Plug the docking station into an electrical outlet.
► If necessary, use a power adapter.
4. Firmly push the data receiver into the docking station to initiate charging. The
docking station’s LED turns red.
Figure 3
x Allow up to 5 hours for the data receiver to fully charge.
x The docking station’s LED turns green when the data receiver is fully charged.
Caution
Charging or recharging the data receiver with a power source other than the SmartPill power supply may
permanently damage the data receiver, docking station, or system computer and will void the product
warranty.