User's Manual

How to use
1. Please install the transmitter module of purchasing to transmitter.
(Please join the cable connector below the module, if you use the Futaba 12FG or 14ZH)
IMPORTANT : Transmitter should switch the PCM mode to PPM mode.
2. Please connect receiver to the servo and battery which you use as below, after checking the
polarity of them. Notice polarity (+) (-), installing battery and servo.
3. After connecting between the transmitter and receiver, switch on the transmitter.
Bleeping “Beep” from the buzzer on the transmitter, after blinking twice the blue LED and then
flickering the green LED slowly.
4. Push the “ID SET KEY” on the transmitter for a period of 2 second then blinking the blue LED.
5. This time push the “ID SET KEY” on the receiver for a period of 2 second by tweezers or other
things. After that, the transmitter module bleeps “Beep, Beep” twice and then turn on the
green LED on the receiver.
6. It should complete binding if the green LED on transmitter module and receiver turns on.
- After that, checking the operation of serve by moving the lever of controller.
The order of binding is as below. ( Two-way communications at ID setting)
1. When you push the “ID SET KEY” on the transmitter, the transmitter send the data to receiver.
2. When you push the “ID SET KEY” on the receiver, the receiver search the data from transmitter.
3. When the receiver finds the data of transmitter, the receiver send the ACK date to transmitter.
4. When the transmitter receives the data of receiver, notifying completed blinding via the buzzer
(OK tone) on the transmitter.
Notice : When you turn on the Futaba 12GF or 14ZH, if you read the comment “RF Module is not
attached. Continue?”, push the “YES”.
(It is no problem operation, if blinking the red light during the operating)
The Product Specification
TX(RF Module)
GT-12/GT-9F/GT-9M
Model GT-12 GT-9F GT-9M
Frequency 2.405~2.480GHz