Installation Guide

HOMEDEPOT.COM
Please contact 1-855-HD-GLACIER for further assistance.
5
Installation (continued)
3
Preparing the pop-up assembly
□ Remove the stopper (E) and ange (F).
□ Screw the nut (H) all the way down, and push
the gasket (G) down.
4
Installing the pop-up body and
pop-up flange
□ Apply silicone to the underside of the ange (F).
□ Insert the pop-up body (I) into the sink. Screw
the ange (F) onto the pop-up body (I). The
pivot hole (1) must face the back of the sink.
□ Use the groove joint pliers to tighten the nut (H),
but do not over tighten. Do not turn the pop-up
body (I) while tightening the nut (H) or the
sealant may not seal properly. Clean away any
excess putty.
5
Installing the horizontal rod,
stopper, and strap
□ Remove the pivot nut (J).
□ Install the horizontal rod (K) and stopper (E), as
shown (1).
□ Hand tighten the pivot nut (J).
□ Attach the horizontal rod (K) to the strap (N)
using the clip (L).
F
E
H
G
SILICONE
I
F
1
H
J
K
E
1
N
L