Installation Guide

HOMEDEPOT.COM

Please contact 1-855-HD-GLACIER for further assistance.

Installation

Installing the faucet assembly

CAUTION: Always turn off the water supply before

removing an existing faucet or replacing any part of a

faucet. Open the faucet handle to relieve water pressure

and ensure that the water is completely shut off.

□ Shut off the water supply. Remove the old

faucet.

□ Place the gasket (B) onto the bottom of the new

faucet assembly (A).

□ Place the faucet assembly (A) through the

mounting holes in the sink.

□ Secure the faucet assembly (A) to the sink

using the washers (C) and nuts (D) provided.

NOTE: If the sink is uneven, use silicone under the

gasket (B).

Making the waterline

connections

NOTE: The hot side inlet tube is indicated by a label.

If the label is not present, the hot supply tube is the longer

of the two inlet tubes.

□ Use 1/2 in. I.P.S. faucet connections (2), or use

supply line coupling nuts (3) (not included) with

a 3/8 in. O.D. ball-nose riser (1).

NOTE: Before tightening the faucet connector to the water

supply, apply a second wrench to the supply tube tting.

This will prevent the supply tube from moving or twisting

when tightening the faucet connector. Do not overtighten.