Installation Guide

7
Installation (continued)
5
Attaching the quick connector
to the hose
□ After inserting the hose through the hole in the
sink surface, reattach the quick connector (J)
by screwing it onto the threaded end of the
hose (1) in a clockwise motion. Hand tighten
only.
6
Attaching the quick connector
to the receiving block
□ Push the quick connector (J) rmly upward and
attach it to the receiving block (1). Pull down
moderately to ensure the connection has been
made.
□ If it is necessary to remove the quick connector
(J), squeeze the tabs on the hose and then pull
down to disconnect.
□ After connecting the hose, install the weights (I)
at the lowest point of the hose.
HOMEDEPOT.CA
Please contact 1-855-HD-GLACIER for further assistance.
1
J
1
J
I
Weights
here
Weights
here